Save these instructions. For your safety, read and understand the information contained within. The owner and
operator shall have an understanding of this product and safe operating procedures before attempting to use this
product. Instructions and Safety information shall be conveyed in the operators native language before use of this
product is authorized. Make certain that the operator thoroughly understands the inherent dangers associated with the
use and misuse of the product. If any doubt exists as to the safe and proper use of this product as outlined in this
factory authorized manual, remove from service. Inspect before each use. Do not use if broken, bent, cracked or
otherwise damaged parts are noted. If any component of this product has been or suspected to have been subjected
to a shock load (a load dropped suddenly, unexpectedly upon it), discontinue use until checked out by an authorized
factory service center. Owners and operators of this equipment shall be aware that the use and subsequent repair of
this equipment may require special training and knowledge. It is recommended that an annual inspection be done by
qualified personnel and that any missing or damaged parts, decals, warning / safety labels or signs be replaced with
factory authorized replacement parts only. Any component of this Body Repair Kit that appears to be damaged in any
way, is worn or operates abnormally shall be removed from service immediately until such time as it can be repaired/
replaced. Labels and Owner's Manuals are available from manufacturer (see Replacement Parts, pages 5, 6).
PRODUCT DESCRIPTION
The Atd Tools Hydraulic Body Repair Kits are designed to be used for pushing, spreading, and pressing of vehicle
body panels as well as various component parts and assemblies. A variety of attachments are included. Atd-5800
pump is rated 8,000 PSI, Atd-5810 is rated 10,000 PSI. Rams are rated from 4 to 10 tons. WARNING: when
extension tubes and/or offset attachments are used, the rated capacity is always reduced by 50 % for each
tube or offset attachment connected. See Parts Section for identification of "offset" attachments.
2
Figure 1 - Atd-5800 and Atd-5810 Nomenclature
BEFORE USE
Use Fig. 1 as reference
1. Inspect before each use. Do not use if bent, broken,
leaking or damaged components are noted.
2. Ensure that product and application are compatible.
3. Check to ensure that all parts of your kit are included
(see illustration and parts list).
4. Carefully remove the dust caps and plugs from hose
coupler and ram coupler.
5. Connect hose coupler to ram coupler, ensure that there
are no fluid leaks.
6. Locate and open release valve. Close release valve
clockwise and pump handle until ram is fully extended,
then open release valve counter-clockwise until ram
has fully retracted.
7. With ram fully retracted and release valve open, place
pump in horizontal position. Locate and open oil filler
screw (on reservoir body, near the back). This will re-
lease air trapped within the reservoir. Retighten the oil
filler screw.
pump handle
release valve
ram plunger
oil filler screw
dust cover
hose
hose coupler
ram
coupler
SPECIFICATIONS
Atd-5800 14 ~127.6 Lbs
Blow Mold Case
CapacityModel
Closed Height
11"
13 5/8"
Number of
Attachments
Operating
Force
Extended Height
19 3/4" 13 ~134.2 Lbs10 TonAtd-5810
15 3/4"4 Ton
