724-746-5500 | blackbox.com
Pag e 116
Chapter 7: Command-Line Management
4. Example:
The following example shows the use of rate-control ingress VALUE (10 mega bits) to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#rate-control ingress 10m
switch_a(config-if)#
RMON Statistics
1. Command Mode: Exec mode or Privileged Exec mode
Logon to Exec Mode (View Mode) or Privileged Exec Mode (Enable Mode).
The switch_a> or switch_a# prompt will show on the screen.
switch_a>
switch_a#
2. Usage:
Use the show interface statistics command to display RMON statistics of interface.
3. Command Syntax:
show interface statistics IFNAME
IFNAME specifies the name of the interface for which RMON statistics is desired.
4. Example:
The following example shows the use of show interface statistics to display RMON statistics of the interface fe1 (port 1):
switch_a>show interface statistics fe1
Per Port VLAN Activities
1. Command Mode: Exec mode or Privileged Exec mode
Logon to Exec Mode (View Mode) or Privileged Exec Mode (Enable Mode).
The switch_a> or switch_a# prompt will show on the screen.
switch_a>
switch_a#
2. Usage:
Use show vlan command to display information about a particular VLAN by specifying the VLAN ID.
3. Command Syntax:
show vlan <2-4094>
<2-4094> VLAN ID.
4. Example:
The following is an output of show vlan command displaying information about VLAN 2:
switch_a>show vlan 2
