Introduction
1-19
1.6.1 Command Syntax Conventions
The following conventions apply as you use LCM commands:
• Press the Enter key to execute a command after you type it in.
•A port range is either a single port number, or a list of port
numbers separated by commas or hyphens. For example, 3 is
port
3; 3,7 are ports 3 and 7; 3-5 are ports 3,4, and 5; and 3-5,7
are ports
3,4,5, and 7.
• To quit any command, press the Control-C keys (^C or Ctrl-C).
• You can abbreviate any command where there is no ambiguity;
if there is ambiguity, LCM responds with an error message.
• Commands are not case sensitive.
• Any invalid commands or misspellings will receive an error
message.
• A previous command can be repeated by typing !!
• MAC addresses are displayed in little-endian Ethernet (least
significant bit) bit order, with each octet separated by a colon.
For example:
ELS10-26 >address 00:40:27:04:1a:0f
• Information that you need to enter with an LCM command is
enclosed in square brackets [ ]. For example, you must enter a
port number and an IP address to execute the
ipaddr [PORT-
NUMBER] [IP ADDRESS]
command:
ELS10-26 >ipaddr 6 192.138.217.40
• Parameters that appear in all capital letters, for example bridge
[PORT-RANGE]
, indicate that you must enter a value for that
parameter. If a string of parameters is displayed between braces,
for example
[{off|on|noBPDU}], you must select one of the
displayed options. For example, if you wanted to enable
bridging on a port, or a range of ports, you would enter:
ELS10-26 >bridge 2-4 on
