Page 3SKU 47246
12. Check for damaged parts. Before using any tool, any part that appears damaged should be
carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and
any other condition that may affect proper operation. Any part that is damaged should be
properly repaired or replaced by a qualified technician.
13. Replacement parts and accessories. When servicing, use only identical replacement parts.
Use of any other parts will void the warranty. Only use accessories intended for use with this
tool. Approved accessories are available from Harbor Freight Tools.
14. Do not operate tool if under the influence of alcohol or drugs. Read warning labels on
prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If
there is any doubt, do not operate the tool.
15. Maintenance. For your safety, service and maintenance should be performed regularly by a
qualified technician.
Warning: The warnings, cautions, and instructions discussed in this instruction manual can-
not cover all possible conditions and situations that may occur. It must be understood by the
operator that common sense and caution are factors which cannot be built into this product,
but must be supplied by the operator.
Additional Jack Safety Precautions
1. Do not overload this equipment. Know the weight of the item being lifted. Attempting to lift
a load exceeding weight capacity can cause jack to fail leading to property damage and/or
personal injury.
2. Do not work under vehicle being lifted by the Jack.
2. Use Jack for lifting only. Do not use this equipment for any other purpose. Immediately after
lifting, support the load with appropriate supporting equipment.
3. Place Jack correctly. Only use this equipment on a surface that is stable, level, hard and
dry, and capable of sustaining the load.
4. Stabilize load. Ensure that the load remains stable at all times. Do not move load while on
the Jack. Lift dead loads only.
5. Vehicle lifting. When lifting a vehicle, apply the emergency brake, and block all wheels.
6. Center Load. Center the load on the Jack Saddle. Off center loads can damage the seals,
causing Jack failure.
7. Not to be used for aircraft purposes.
8. Do not move the vehicle while it is on the Jack.
9. Do not make any alterations or modifications to this Jack.
10. Consult vehicle’s manual for advised lift points. Only use advised lift points when using
Jack. Lifting in other areas can cause damage to vehicle and cause unplanned, sudden lower-
ing of vehicle.
Unpacking
When unpacking, check to make sure the following parts are included: Assembled Frame and
Handle Assembly (20, 21, 22, 23). Refer to the Parts Lists and Assembly Drawings at the end of this
manual. If any parts are missing or broken, please call Harbor Freight Tools at the number on the
cover of this manual as soon as possible.
REV 02g; 03f; 08i
