Page 13
SKU 93167
For technical questions, please call 1-800-444-3353
Attaching Leg Assembly
In order to use the Trencher, the Leg Assemblies must be installed next to the Main Boom
(36), and the Wheels (78) and Axle and Hub Assembly (50) moved the rear of the Trencher.
1. On a flat earthen surface, start the engine and use the Boom Controls to first curl the
bucket towards the boom without touching the ground and then to force the Bucket As-
sembly (32) down to the ground forcing the Frame Assembly (90) to rise. Lift the Tires
just off the ground and stop. Refer to Starting the Engine and Boom Controls on the fol-
lowing pages.
2. Make sure that the controls will not be touched or bumped and that the Trencher
will remain motionless. NEVER PLACE ANY PART OF YOUR BODY UNDER THE
TRENCHER, ESPECIALLY IF IT IS RAISED IN THIS FASHION.
3. When the Tires (52) are off the ground, remove the Wheel (78) and Axle Assembly (50)
to the operator’s left, and replace with the Left Extension Leg (45) and Leg Assembly
(24). Make sure that the Extension Leg is directed so that it turns toward the Bucket end
of the Trencher. Secure with Lock Pin No. 1 (20). Repeat procedure for the right side.
Raise Bucket Assembly again to lower onto Leg Assembly, and turn Engine off.
4. Using a jack (not included) and assistance, raise up the engine end of the trencher and
disconnect from the towing hitch, if you have not already done so. Slide the Wheels (78)
and Axle Assembly (50) into the engine end of the Frame (90). Secure each axle with
Lock Pin No. 2 (82). The completed assembly should resemble the illustration below.
Leg Assembly
(24)
REV 07f
