A SERVICE OF

logo

Black plate (62,1)
Chevrolet Impala Owner Manual - 2013 - CRC - 4/23/12
10-62 Vehicle Care
WARNING (CONTINUED)
add water to take care of that
first. If you do not, explosive gas
could be present.
Battery fluid contains acid that
can burn you. Do not get it on
you. If you accidentally get it in
your eyes or on your skin, flush
the place with water and get
medical help immediately.
{
WARNING
Fans or other moving engine
parts can injure you badly. Keep
your hands away from moving
parts once the engine is running.
5. Connect one end of the red
positive (+) cable to the jump
start positive (+) post. Use a
remote positive (+) terminal if
the vehicle has one.
6. Do not let the other end of the
red positive (+) cable touch
metal. Connect it to the
positive (+) terminal of the
good battery. Use a remote
positive (+) terminal if the
vehicle has one.
7. Connect one end of the
black negative () cable to the
negative () terminal of the
good battery. Use a remote
negative () terminal if the
vehicle has one.
Do not let the other end touch
anything until the next step.
The other end of the negative ()
cable does not go to the dead
battery. It goes to a heavy,
unpainted metal engine part or
to a remote negative () terminal
on the vehicle with the dead
battery.
8. Connect the other end of the
black negative () cable to an
unpainted heavy metal engine
part away from the dead battery,
but not near engine parts
that move.
9. Start the engine in the vehicle
with the good battery and run
the engine at idle speed for at
least four minutes.
10. Try to start the vehicle that had
the dead battery. If it will not
start after a few tries, it
probably needs service.
Notice: If the jumper cables are
connected or removed in the
wrong order, electrical shorting
may occur and damage the
vehicle. The repairs would not be
covered by the vehicle warranty.
Always connect and remove the
jumper cables in the correct
order, making sure that the
cables do not touch each other or
other metal.
Jumper Cable Removal
Reverse the sequence exactly when
removing the jumper cables.