Installation Instructions
20
4. Install two 8-32 x 3/8" button head security screws (AA) into
lower cover. (See Figure 44)
Figure 44
5. Replace upper cover and install two 8-32 x 3/8" button head
security screws (AA) into upper cover. (See Figure 45)
Figure 45
Stop Bracket
1. Remove two bolts holding stop bracket in place on
underside of short throw projector mount. (See Figure 46)
Figure 46
2. Install two 1/4-20 x 1/2" button head security screws (T)
through holes in stop bracket and into holes in sliding nuts.
(See Figure 47)
Figure 47
Adapter Plate Bolts
1. Remove projector from short throw projector mount
according to projector interface instructions.
NOTE: For most projectors, it will be necessary to remove
projector prior to installing four security screws to
projector bracket. For ease of installation, it is
recommended to remove projector prior to performing
the following steps.
WARNING: It is important to replace adapter plate bolts
ONE AT A TIME or adapter plate could fall from mount during
installation!
6
(AA) x 2
7
(AA) x 2
x 2
1
Stop bracket
2
(T) x 2
Stop
bracket
Sliding nuts
locations
