Coleman 5177 Manual

A SERVICE OF

next previous

English - 4

■ Push lighted match

through lighting hole,

hold near mantle and

open fuel valve fully.

(Fig. 15)

Match Light

Lantern

INSTASTART™

Electronic

Ignition Lantern

CAUTION

r4&37*$&4"'&5:

rKeep all connections and ttings clean.

Inspect propane cylinder and lantern propane

connections for damage before attaching.

rDuring set up, check all connections and

ttings for leaks using soapy water. Bubbles

indicate a leak. Never use a ame.

■ Open burner valve

and repeatedly push

igniter button and

ignite the mantles.

(Fig. 16)

Fig. 15 Fig.16

WARNING

r#63/)";"3%

r/FWFSMFBWFMBOUFSOVOBUUFOEFEXIFOIPU

or in use.

r,FFQPVUPGSFBDIPGDIJMESFO

NOTE: If lantern does not

light, repeat above step. If

the lantern does not light

after several attempts,

check for a spark while

clicking the igniter. If no

spark is present, check

the electrode gap. The

gap should be about

.2” (5.0 mm). Carefully

bend electrode to set

gap. If the lantern is wet

due to rain, high humidity, etc., the electrode may

not spark. Use lighting procedure for match light

version lanterns. (Fig. 17)

■ Brightness may be

adjusted with

fuel valve. (Fig. 18)

Fig. 18

To Turn Off

■ .BLFTVSFMBOUFSO

is cool.

■ .PWFMBOUFSOBXBZ

from ame (including

pilot lights) and other

ignition sources.

■ Remove propane

cylinder from lantern.

(Fig. 20)

■ Replace protective cap

on propane cylinder .

■ Turn fuel valve

off. (Fig. 19)

Fig. 20

To Store

Fig. 19

DANGER

r&91-04*0/'*3&)";"3%

r/FWFSTUPSFQSPQBOFOFBSIJHIIFBUPQFO

ames, pilot lights, direct sunlight, other igni-

tion sources or where temperatures exceed

120 degrees F (49°C).

r5IFDZMJOEFSNVTUCFEJTDPOOFDUFEXIFOUIF

lantern is in storage.

■ Lantern can

be placed in

base for secure

storage. (Fig. 21)

Fig. 21

Fig. 13

Fig. 14

■ Reecting position.

Bottom tab rests

inside lantern frame.

(Fig. 13)

■ Storage position.

Reector hangs from

back rails. (Fig. 14)

.2”

(5.0 mm)

Fig. 17

■ Assemble reector to back of lantern. Position

the reector clips onto the center of the two

back rails and

slide either upward

into the reecting

position or

downward into the

storage position.

(Fig. 12)

Fig. 12