A SERVICE OF

logo

Open as PDF
next previous
22
5/16" NYLOCK NUT (CC)
CHUTE CRANK
BRACKET
5/16" WASHER (U)
CHUTE
CRANK
ROD
ROD
SUPPORT
BRACKET
5/16" x 1"
CARRIAGE BOLT (N)
SPIRAL
FIGURE 51 LEFT SIDE VIEW
FIGURE 52 RIGHT SIDE VIEW
CHUTE KEEPER (HH)
ANTI-ROTATION
BRACKET
1/4" FLANGED
LOCK NUT (Z)
1/4" FLAT
WASHER (T)
1/4" x 1"
HEX BOLT (F)
PLASTIC CAP (NN)
GREASED
SURFACE
FLANGE
STEP 53: (SEE FIGURE 52)
• Coatthetopoftheringaroundthedischargeopening
with general purpose grease.
• Placethedischargechute(facingforward)ontothe
ring. Place the anti-rotation bracket on top of the chute
ange,aligningitwiththeholesontherighthandside
oftheange.Attachthethreechutekeepers(HH)
(rightsideupasshown)tothebottomoftheange
usingsix1/4"x1"hexbolts(F),1/4"atwashers(T)
and1/4"angedlocknuts(Z).Tighten carefully so
that the nuts are snug but do not dig into the plastic
chute keepers.
• Placetheplasticcap(NN)ontotheshortendofthe
anti-rotation bracket.
• Positionthecrankrodspiral(seegure51)sothatit
does not rub against the bottoms of the notches in the
chuteange.Tighten the nuts.
• Checkifthecrankrodrotatesthechutefreely.Ifnot,
loosen by 1/4 turn each of the six hex bolts holding
thechutekeeperstothechuteange.
• Securethecontrolcablestothecrankrodsupport
tube using a nylon tie (OO).
STEP 54: (SEE FIGURE 53)
Skip this step if you have a lawn tractor.
This step is for garden tractors only.
• Ifyouhavea(GT)GardenTractor,removethestop
bolts from each side of the snow thrower frame.
STEP 52: (SEE FIGURE 51)
• Attachthechutecrankrodassemblybracketsto
the plastic bracket on the left side of the discharge
housing. Align the chute crank bracket beneath the
rod support bracket and assemble both to the plastic
bracket using two 5/16" x 1" carriage bolts (N), 5/16"
washers (U) and 5/16" Nylock nuts (CC). Do not
tighten yet.
STOP BOLT
FIGURE 53 RIGHT SIDE VIEW