
$£RV C£ AN ADJUSTMENTS
TO LEVEL MOWER HOUSING FRONT-TO-BACK ADJUSTMENT (See Figs° X3 and X4)
Adjust the mower while tractor is parked on level ground or
driveway. Make sure tires are properly inflated (See
"PRODUCT SPECIFICATIONS" on page 3 ofthis manual).
If tires are over or underinflated, you will not properly adjust
your mower°
SIDE-TO-SIDE ADJUSTMENT(See Figs° 21 and 22)
• Raise mower to its highest position_
• At the midpoint of both sides of mower, measure height
from bottom edge of mowerto ground° Distance "A"on
both sides of mower should be the same or within 1/4"
of each other.
If adjustment is necessary, make adjustment on one
side of mower only,.
To raise one side of mower, tighten lift link adjustment
nut on that side.
o To lower one side of mower, loosen lift link adjustment
nut on that side.
NOTE: Each full turn of adjustment nut will change mower
height about 1/8"_
. Recheck measurements after adjusting..
BOTTOM EDGE BOTTOM EDGE
OF MOWER TO OF MOWER TO
GROUND GROUND
IMPORTANT; DECK MUST BE LEVEL SIDE-TO-SIDE, IF
THE FOLLOWING FRONT-TO-BACK ADJUSTMENT iS
NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS
EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO-
SIDED
To obtain the best cutting results, the mower housing
should be adjusted so that the front is approximately 1/8" to
1/2" lower than the rear when the mower is in its highest
position.
Check adjustment on right side of tractor_ Measure dis-
tance "D" directty in front and behind the mandrel at bottom
edge of mower housing as shown°
o Before making any necessary adjustments, checkthat
both front links are equal in length_ Both links should be
approximately 10-3/8'L
• If links are not equal in length, adjust one link to same
length as other linko
• To lower front of mower loosen nut "E" on both front
links an equal number of turns°
° When distance "D" is 1/8" to I/2" lower at front than
rear, tighten nuts "F" against trunnion on both front
links°
° To raise front of mower, loosen nut"F" from trunnion on
both front links. Tighten nut "E" on both front links an
equal number of turns°
• When distance "D" is 1/8" to 1/2" lower at front than
rear, tighten nut "F' against trunnion on both front links.
Recheck side-to-side adjustment
GROUND LINE A
FIG. 21
LIFT LINK
ADJUSTMENT NUT
FIG. 22
__ %,, "", t o o_ MANDREL
FIG. 23
BOTH FRONT LINKS MUST BE EQUAL IN LENGTH
NUT "F"_ NUT "E"
FRONT LINKS TRUNNION
FIG. 24
21