PositiveTerm/.hal
Hex Bolt
Positive Terminal
Charged
Battery
Negative Terminal
REPLACING •BATTERY
ACAUTION: Do not short battery termi-
nals by allowing a wrench or any other
object to contact both terminals at the
same time. •Before connecting battery,
remove metal bracelets, wristwatch
bands,rings,etc.
Positive terminal must be connected first
to prevent-sparking from accidental
grounding. '
• Lift seat pan to raised position and open
battery box door.
• Disconnect BLACK batterycable first
then RED battery cable and carefully
remove battery from tractor.
•.-Install new battery with terminals in
same position as old battery.
• First connect RED battery cable to posi-
tive (+) terminal with hex bolt and nut as
shown. Tighten securely.
ConnectBLACK grounding cable to
negative (-) terminal with remaining hex
boR and nut. Tighter_securely.
Close battery box door.
Seat Pan
Battery Box
Door
Positive (Red) Cable Negative (Black) Cable
TO REP=LACE HEADLIGHT BULB
• Raise hood.
• Pull bulb holder out of the hole in the
backside of the grill.
• Replace bulb in holder and push bulb
holder securely back intothe hole in the
backside of the grill.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stoprunning, or pre-
vent it from starting.
• Check wiring. See electrical wiring dia-
gram in the Repair Parts section of this
manual.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL
ASSEMBLY --;-
• Raise hood.
• Unsnap headlight wire connector.
• Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
• To replace, reverse above procedures.
ENGINE
Maintenance, repair, or replacement of the
emission control devices and systems,
which are being done at the customers
expense, may be performed by any •non-
road engine repair establishment or indi-
vidual. Warranty repairs must be per-
formed by an authorized engine manufac-
26 turer's service outlet.
