Configuring Switch Information 251
The following is an example of the CLI commands:
console(config)# interface ethernet 1/e3
console(config-if)# description "RD SW#3"
console(config-if)# shutdown
console(config-if)# no shutdown
console(config-if)# speed 100
console(config-if)# duplex full
console(config-if)# negotiation
console(config-if)# back-pressure
console(config-if)# flowcontrol on
console(config-if)# mdix auto
console(config-if)# end
console# show interfaces configuration ethernet 1/e3
Port Type Duplex Speed Neg Flow
Control
Admin
State
Back
Pressure
Mdix
Mode
---- ----- ------ ------ ---- ------ ----- ------ ----
1/e3 100 Full 100 Enabled On Up Enable Auto
Console# show interfaces status
