86 Command Groups
Spanning Tree
radius-server deadtime Improves RADIUS response times when servers
are unavailable. Causes the unavailable servers
to be skipped.
GC
radius-server host Specifies a RADIUS server host. GC
radius-server key Sets the authentication and encryption key for
all RADIUS communications between the
switch and the RADIUS daemon.
GC
radius-server retransmit Specifies the number of times the software
searches the list of RADIUS server hosts.
GC
radius-server source-ip Specifies the source IP address used for
communication with RADIUS servers.
GC
radius-server timeout Sets the interval for which a switch waits for a
server host to reply
GC
retransmit Specifies the number of times the software
searches the list of RADIUS server hosts before
stopping the search.
R
show radius-servers Displays the RADIUS server settings. PE
show radius-servers
statistics
Shows the statistics for an authentication or
accounting server.
PE
source-ip Specifies the source IP address to be used for
communication with RADIUS servers.
R
timeout Sets the timeout value in seconds for the
designated radius server.
R
usage Specifies the usage type of the server. R
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 64.
Command Description Mode*
clear spanning-tree
detected-protocols
Restarts the protocol migration process on all
interfaces or on the specified interface.
PE
exit (mst) Exits the MST configuration mode and applies
configuration changes.
MC
Command Description Mode*
