4
• DO NOT leave the engine/motor running
unattended.
• Always operate the saw in well-
ventilated areas. Concentrated engine
exhaust can cause loss of
consciousness and/or death.
• DO NOT touch the engine/muffler assembly with the
engine running, and always let them cool down prior
to touching or servicing the saw.
• Handle hot oil carefully when changing the oil.
• Wipe down the engine/motor exterior and guards
daily or regularly to prevent high operating
temperatures. DO NOT spray the engine/motor with
water to prevent engine/motor damage.
• Let the engine cool prior to removing
pressurized caps (applicable
models).
• DO NOT use any starter substances or starter fluids
(e.g., starter fluid sprayed into the air filter) when
starting the engine using a glow plug (applicable
models). These materials are extremely flammable
and explosive, and can melt parts or possibly
explode when used to help start the engine.
• All electric motor saws should be properly grounded
prior to operating.
• DO NOT supply less or more power to the electric
motor saw than what the motor is rated for.
• DO NOT use a hydraulic power unit that supplies
less power to the hydraulic motor saw than required.
Cutting Safety
• The direct work area should not contain buried or
embedded electrical, gas, or water lines that could
be damaged and/or cause personal injury while
cutting.
• Turn off all electricity, gas, and water around the
direct work area prior to cutting.
• DO NOT expose yourself or anyone
else to the direct line of the blade
when operating the saw.
• DO NOT allow any person, animal, and/or object in
and around the work area while cutting.
• When using an electric motor saw, be aware of all
active electrical lines if using power from the direct
work area to operate the saw.
Hydraulic Safety
• DO NOT disconnect hydraulic hoses when the saw
is running.
• Always place a piece of cardboard or
paper up against hydraulic
components, or use a leak detection
fluid to check for hydraulic fluid
leaks. Keep all body parts away from leaks and/or
areas that may eject hydraulic fluid. Pressurized
hydraulic fluid can penetrate the skin, causing
serious injuries. Seek medical attention immediately!
Belt Safety
• Turn off the engine/motor and let the belts cool down
prior to servicing them.
• Regularly inspect the belts for fraying, stress cracks,
and/or breakage and replace immediately when
damaged. Always check belt alignment prior to
operating the saw.
• Over-tensioning the belts may damage the engine
crankshaft. Under-tensioning the belts may cause
slippage, shorter belt life, and/or poor saw
performance.
• Squealing belts indicate looseness.
• DO NOT use old and new belts on the same sheave
together.
Transporting Safety
• Remove the blade prior to transporting the saw.
• Make sure the truck/trailer is in good, working
condition and sufficient to transport the load. DO
NOT tow the saw behind a vehicle.
• Close the fuel shutoff valve when transporting.
• Drain the fuel tank when transporting long distances.
• Use heavy-duty ramps that will support the weight of
the saw and yourself when loading or unloading.
• Raise the saw to avoid damaging components while
moving up and down ramps.
• Use extreme caution when guiding
the saw up and down ramps. Slowly
drive/push the saw forward down
the ramp. Slowly back/pull the saw
in reverse up the ramp. Avoid
standing directly downhill from the saw to avoid
serious injuries.
• Chock the wheels and secure the saw in a
truck/trailer prior to transporting.
• Turn off the engine/motor once the saw is loaded
into the truck/trailer. For self-propelled models, place
the speed control lever at Neutral and engage the
transmission prior to turning off the engine.
• Engage the brake once the saw is secure in the
truck/trailer to help secure.
• Refer to the Department of Transportation (DOT) for
additional transporting recommendations.
