21
Dukane Manual Part No. 403–566–01
Section 3 – Unpacking and Installation
Ꮨ
Ꮨ
ƽ
DUKANE CORP
ST. CHARLES, IL 60174
MADE IN USA
SERIAL NUMBER
US 10000
– WARNING! –
POWERLINE MUST BE GROUNDED
AT OUTLET
REMOVE ALL POWER BEFORE
REMOVING COVER OR CONNECTING
OR DISCONNECTING CABLES.
ULTRASOUND
OUTPUT
SYSTEM OUT
+
–
Power Monitor
Jacks
Power Signal
Output Module
Power
Signal
Output
Zero
Adjust
SYSTEM IN
J1
U.S.PATENT 4,277,710
– WARNING–
POWER LINE MUST BE
GROUNDED AT OUTLET
LINE VOLTAGE
200–240Vac 50/60Hz
15A
MODEL NUMBER
200-240 VAC, 50-60Hz, 15A
Earth Ground
#14 Gauge
Wire
110 VAC or
220 VAC
Grounding Lug
Grounding Lug
Ultrasound
Input
Automation
Control
Status
Output
P/N 200–1302
Coaxial Cable
RG62B/U
#14 Gauge Wire
Automation
Equipment
P/N 200–1203
P/N 200–479
Ẅ
Ẅ
ẈẇẆ
ẅ
ẅ
Ꮨ
Ꮨ
ƽ
DUKANE CORP
ST. CHARLES, IL 60174
MADE IN USA
SERIAL NUMBER
US 10000
– WARNING! –
POWERLINE MUST BE GROUNDED
AT OUTLET
REMOVE ALL POWER BEFORE
REMOVING COVER OR CONNECTING
OR DISCONNECTING CABLES.
ULTRASOUND
OUTPUT
SYSTEM OUT
+
–
Power Monitor
Jacks
Power Signal
Output Module
Power
Signal
Output
Zero
Adjust
SYSTEM IN
J1
U.S.PATENT 4,277,710
– WARNING–
POWER LINE MUST BE
GROUNDED AT OUTLET
LINE VOLTAGE
200–240Vac 50/60Hz
15A
MODEL NUMBER
200-240 VAC, 50-60Hz, 15A
J901 TO THRUSTER
J902 BASE/
ABORT
Jumper Block
Part No. 200–1293
Pins 3 & 9
Connected
1
5
3
69
Earth Ground
#14 Gauge
Wire
Flexible + Coaxial Cable
20kHz Part No. 200–624
40kHz Part No. 200–759
(Included with probe)
Grounding Lug
110 VAC or
220 VAC
14–Pin AMP to
HD–15 Adapter
Part No. 200–1248
ẄẈ
ẉ
ẇ
Ẇ
ẅ
The 3–prong AC Line cords supplied are
matched to the DPC II Plus power rating and
the continent of specified use.
The part numbers are —
200–1109 North America 110V
200–1110 North America 220V
200–1111 Continental Europe
Figure 3-4 DPC II Plus and EZ Welder Hand Probe Cable Connections
Figure 3-5 DPC II Plus and EZ Welder Automated Probe Cable Connections
Table 3—II DPC II Plus AC Power Cord Part Numbers
Step 4. Optional – Attach the status output
cable from the user–supplied
automation equipment to the System
Output DB-25 connector. Not all
automation systems will have this cable.
Step 5. Attach the power cord to the DPC II
Plus and plug the other end into an
approved AC outlet.
