CAUTION: Completely assemble vacuum cleaner before
Assembly Packet is with ownerʼs guide.
Push lower handle into handle socket on the base.
: Check to be sure slot in handle is positioned
Align the holes on the lower handle and the socket. Insert
a 2-part bolt (A) in the bottom center of the handle and
Push upper handle onto lower handle. Make sure grip curves
Align the holes on the upper handle
to the holes on the lower handle. Insert a 2-part bolt (A)
in center of the handle and tighten.
Make sure cord hook is pointing downwards. Press the power
cord into the groove on the cord hook pulling any slack toward
the base of the cleaner. On the cord hook, fi nd the curved
tab and place in slot on lower handle section, keep cord taut
while pressing the cord hook to the left until it snaps into slot
on opposite side of handle. The hook should point downward
on the same side that the cord exits the hood.
: To provide a good gasket seal, the bag
coupling must seat firmly against the
Hold outer bag with zipper away from the handle. Line up
screw holes. Start the bag screws by hand, then tighten with
Loop the bag spring onto the bag support hook located at the
back of the upper handle section.
The cleaner has two convenient cord storage hooks attached
to the handle. However, some models feature a quick release
cord hook on the upper handle. A downward twist of the cord
hook frees the cord for quick removal. With either style, wind
the cord around the hooks for storage. Fasten the plug to the
cord to prevent unwinding.
