What’s in the carton
STEP
1
1
Easy assembly
Slide upper housing onto
vacuum body. Fasten with
2 medium screws (A).
Insert handle until mark
aligns with top of housing.
Fasten with 1 long screw (B).
S
lide tool caddy onto housing.
Sides will click into position.
Press firmly to snap hose
retainer onto back of
v
acuum body.
STEP
2
2
Get ready to vacuum
Step on power switch to turn
on; step on again to turn off.
Step on handle release to
lower handle into position.
Push down release button and
pull out handle to desired height.
Pull out full length of cord;
push into cord retainer.
For accessories: Loosen end of
wand, pull out and attach tool.
If vacuum is hard to push, use
foot to raise carpet setting.
Lift latch to remove dust cup.
Empty after each use.
Press button to rewind cord.
STEP
3
3
Use a Phillips
screwdriver.
PROBLEM SOLVING
Refer to Owner’s Guide.
MAINTENANCE SCHEDULE
Refer to back of dust cup or Owner’s Guide.
QUICK START GUIDE
4230 Series
Before returning, call
Eureka Customer Service
HELPLINE
1-800-282-2886
8 a.m. to 7:30 p.m. (CST), Monday - Friday
10 a.m. to 6:30 p.m. (CST), Saturday - Sunday
www.eureka.com
T
h
a
n
k
y
o
u
f
o
r
p
u
r
c
h
a
s
i
n
g
y
o
u
r
n
e
w
E
u
r
e
k
a
v
a
c
u
u
m
!
Position hose connector
on back of vacuum. Fasten
with 1 short screw (C).
Pull out bottom of hose
retainer and position hose.
Place hose over hook on
handle. Secure in sides of
tool caddy.
Push end of wand into wand
retainer on side of vacuum.
Place dust cup on body and
snap into place.
Place dusting brush and
crevice tool on tool caddy.
Pull up plug and slip into slot
on tool caddy.
Snap Power Paw
®
into clip on front.
