IDE HDD Block Mode
Using this function on the Integrated Peripherals menu allows your IDE hard
drive needs to support block mode. Select
[Enabled] to automatically
detect the optimal number of block read/writes per sector the drive can
support. Select
[Disabled] if your drive does not support block mode.
MCP Storage Config
Press Enter to display the MCP Storage Config menu.
SATA Operation Mode
This is allows you set the onboard Serial SATA mode.
¾ IDE: Use the Serial ATA hard disk drivers as Parallel ATA storage
devices.
¾ RAID: Create a RAID 0, 1, 0+1, 5 and JBOD configuration.
¾ AHCI: Use the AHCI (Advanced Host Controller Interface) to enables
advanced SATA features for improved performance with NCQ and
Hot-plug features
¾ Linux AHCI: Use the function for Linux AHCI.
SATA SALP Features
This item allows you select the SATA SALP (Aggressive Link Power
Management status. The options are OFF, Partial, Slumber.
Onboard Devices
Press Enter to display the Onboard Devices menu.
HD Audio [INT Codec + EXT Codec]
MAC Lan [Auto]
P80 Show CPU Tem
erature
Enabled
SATA Operation Mode [IDE]
SATA SALP Features [OFF]
