2-5
SW8/12 VGA Ars • Installation and Operation
Mounting through a desktop
Through desktop mounting requires the included MBD1491U,through-deskand
rack mounting kit (part #70-077-03).
MountanSW8/12VGAArsunitthroughadesktopasfollows:
1. If present, remove the four rubber feet from the bottom of the unit.
2. Cutanappropriatelysizedholeinthedesktop.
3. Loosely install the mounting brackets on the unit’s sides with four machine
screws provided in the kit.
4
. Hold the unit (with brackets attached) against the underside of the desk.
Mark each bracket's hole location on the underside of the desk.
5
. Drill1/4"(6.4mm)deep,3/32"(2mm)diameterpilotholesfromthe
underside of the desk at the marked hole locations.
6
. Hold the unit in place so the mounting bracket holes line up with the pilot
holes in the desktop.
7
. Install the four supplied wood screws through the mounting brackets and into
the pilot holes.
8
. Tighten the wood screws to secure the mounting brackets to the underside of
the desktop.
9
. Slide the switcher up or down inside the mounting brackets to achieve the
desired height above the desktop.
10
. Tighten the machine screws to secure the switcher in position.
Figure 2-3 — Mounting the switcher through a desktop
