Assembly
14
16
• With the seat at an angle, insert the tabs on the front
edge of the seat into the slots in the foot-well wall .
• Push down firmly on the edge of the seat above each
tab to snap the tabs into the slots .
• Rotate the back of the seat down to snap the seat
back tabs into the slots in the vehicle body. Push down
firmly on the seat back.
PUSH
HERE
18
17
• Using safety scissors, remove the sport bar brackets
from the plastic connector. Dispose of the plastic
connector.
• Position the sport bar upright.
• Position a sport bar bracket above one of the sport bar
side legs, as shown.
• Insert the tab on the inside of a sport bar bracket into the
hole in the sport bar side leg.
• Fit the ring on a sport bar support against the end of the
sport bar bracket.
• Fold the sport bar bracket over the sport bar to close it
around the sport bar and sport bar support.
Sport Bar
Sport Bar Bracket
Sport Bar Support
Tab
#8 x 1" Screw
Hole
Side Leg
Ring
19
• Insert a #6 x 1
1
/
2
" screw into the sport bar bracket
as shown.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
• Repeat steps 18 and 19 to attach the other sport bar
support to the other sport bar side leg.
• Insert a #8 x 1" screw into the rear of seat as shown.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
Sport Bar Bracket
Sport Bar
Sport Bar Support
