
W1070pr-0920
7
•Makesureyouchargethebatteryforatleast18hours
using the enclosed Power Wheels® 12 volt charger
before operating your vehicle for the first time. Charge
the battery for at least 14 hours after each use of the
vehicle. Never charge the battery longer than 30 hours.
Failure to follow these instructions may damage your
battery and will void your warranty.
•UseonlyaPowerWheels® 12 volt charger with “12V”
connector (input 120 VAC, 60Hz, with an output of
12 VDC) to charge your Power Wheels® 12 volt battery.
BATTERY CHARGING
ELECTRICALHAZARD
WARNING
Usethechargerindrylocationsonly.
CAUTION
•Batterycanfalloutandinjureachild
ifvehicletipsover.Alwaysuse
batteryretainer.
•PREVENT FIRE
-Nevermodifytheelectricalsystem.
Alterationscouldcauseare
resultinginseriousinjuryandcould
alsoruintheelectricalsystem.
-Useofthewrongtypebattery
orchargercouldcauseareor
explosionresultinginseriousinjury.
-UseofPowerWheels
®
components
inproductsotherthanPowerWheels
®
vehiclescouldcauseoverheating,re
orexplosion.
•Thebatterymustbehandledbyadults
only.Thebatteryisheavyandcontains
sulfuricacid(electrolyte).Droppingthe
batterycouldresultinseriousinjury.
•Neverallowchildrentochargethe
battery.Batterychargingmustbedone
byadultsonly.Achildcouldbeinjured
bytheelec-tricityinvolvedincharging
thebattery.
•Readthesafetyinstructionson
thebattery.
•Examinethebattery,chargerand
theirconnectorsforexcessivewear
ordamageeachtimeyouchargethe
battery.Ifdamageorexcessivewear
isdetected,donotusethechargeror
thebatteryuntilyouhavereplacedthe
wornordamagedpart.
•Plugthechargerconnectorintothebatterysocket.
•Plugthechargerintoastandardwalloutlet.
Notes:
- If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
- Use the charger only in a wall outlet. Do not plug the
charger into a ceiling outlet.
•Youdonotneedtoremovethebatteryfromyour
vehicle to recharge it.
•Beforechargingthebattery,examinethebatterycase
for cracks and other damage which may cause sulfuric
acid (electrolyte) to leak during the charging process. If
damage is detected, do not charge the battery or use it
in your vehicle. Battery acid is very corrosive and can
cause severe damage to surfaces it contacts.
•Donotplacethebatteryonasurface(suchaskitchen
counter tops) which could be damaged by the acid
contained inside the battery. Take precautions to protect
the surface on which you place your battery.
•Chargethebatteryinawellventilatedarea.
•Oncethebatteryischarged,disconnectthebattery
connector from the charger connector. Unplug the
charger from the wall outlet. Refer to the Battery
Installation section for instructions on installing your
battery. If your battery is already installed in your
vehicle, simply re-connect the motor harness connector
to the battery.
Charger
Connector
Battery must be upright
while charging.