
26
Toorderyourreplacementlters,pleasevisitouronline
store at www.frigidaire.com/store, by calling toll-free
at 877-808-4195, or by visiting the dealer where you
purchased your refrigerator. Frigidaire recommends that you
orderextralterswhenyourstinstallyourrefrigerator,and
thatyoureplaceyourltersatleastonceeverysixmonths.
Here is the product number to request when ordering:
TM
Water Filter
Part #
Thewaterlterislocatedatthetoprightsideofthefresh
food compartment.
Ingeneral,youshouldchangethewaterltereverysix
months to ensure the highest possible water quality.
on the user interface prompts you to replace
thelterafterastandardamountofwater(200gallons/757
liters for
TM
)
hasowedthroughthesystem.
If your refrigerator has not been used for a period of time
(duringmovingforexample),changethelterbefore
reinstalling the refrigerator.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
thesystem.Systemscertiedforcystreductionmaybeused
ondisinfectedwatersthatmaycontainlterablecysts.
• RatedCapacity-200gallons/757litersfor
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• OperatingTemp.:Min.33°F,Max.100°F
• MaximumRatedPressure-100poundspersquareinch
• RecommendedMinimumOperatingPressure:30
pounds per square inch
TM
It is not necessary to turn the water supply off to change
thelter.Bereadytowipeupanysmallamountsofwater
releasedduringthelterreplacement.
Turn the ice maker power switch.
2 Removethelterbypushingontheend/faceofthe
lter.
3 Slidetheoldwaterltercartridgestraightoutofthe
housing and discard it.
4 Unpackagethenewltercartridge.Usingthe
alignmentguide,slideitgentlyintothelterhousing
until it stops against the snap-in connector at the
back of the housing.
Press a drinking glass against the water dispenser
whilecheckingforanyleaksatthelterhousing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.
7 Afterllingoneglassofwater,continueushingthe
system for about .
8 Turn the ice maker.
9 Press and hold the button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from to , the
status has been reset.
The
TM
iceandwaterlter
systemistestedandcertiedtoNSF/ANSI
Standards 42 and 53 for the reduction of claims
speciedontheperformancedatasheet.
NOTE
Whenorderingyourreplacementlter,pleasereorder
thesameltertypethatiscurrentlyinyourrefrigerator.