Garmin G1000 Cockpit Reference Guide for the DA40/40F
12-15
SECTION 12 – ANNUNCIATIONS
& ALERTS
GMU 44 Message Advisories
Alerts Window Message Comments
HDG FAULT – AHRS1 magnetometer
fault has occurred.
A fault has occurred in the GMU 44. Heading is flagged as invalid. The AHRS uses
GPS for backup mode operation. The G1000 system should be serviced.
MANIFEST – GMU1 software
mismatch. Communication halted.
The GMU 44 has incorrect software installed. The G1000 system should be serviced.
GDL 69 Message Advisories
Alerts Window Message Comments
GDL69 CONFIG – GDL 69 configura-
tion error. Config service req’d.
GDL 69 configuration settings do not match those of backup configuration memory.
The G1000 system should be serviced.
GDL69 FAIL
– GDL 69 has failed. A failure has been detected in the GDL 69. The receiver is unavailable. The G1000
system should be serviced
GDC 74A Message Advisories
Alerts Window Message Comments
GDC1 CONFIG – GDC1 configuration
error. Config service req’d.
GDC 74A configuration settings do not match those of backup configuration
memory. The G1000 system should be serviced.
MANIFEST – GDC1 software
mismatch. Communication halted.
The GDC 74A has incorrect software installed. The G1000 system should be
serviced.
BACKUP PATH – ADC1 using backup
data path.
The GDC 74A is using a backup communications data path. The G1000 system
should be serviced when possible.
Miscellaneous Message Advisories
Alerts Window Message Comments
FPL WPT LOCK – Flight plan waypoint
is locked.
Upon power-up, the G1000 system detects that a stored flight plan waypoint is
locked. This occurs when an aviation database update eliminates an obsolete way
-
point. The flight plan cannot find the specified waypoint and flags this message. This
can also occur with user waypoints in a flight plan that is deleted.
Remove the waypoint from the flight plan if it no longer exists in any database,
OR
update the waypoint name/identifier to reflect the new information.
