Step 4
Install the Cooktop
(continued)
■ Cut gasket strip as required. Peel off the backing
and apply to the underside of the glass cooktop edge,
on each side at least 3/8″ from the back and as close
to the edge as possible without protruding.
■ Apply the other gasket strip to the underside of
the glass at the front of the cooktop.
■ Position the cooktop over the opening, making
sure that the power cord is dropped into the cabinet.
■ Lower the cooktop into the cutout, pressing gently
and evenly to seat.
NOTE:
If the cooktop is installed in a 36″ base
cabinet, the mounting brackets cannot be used
because of interference with the cabinet sides. In this
case, the cooktop can be secured to the cabinet with
angle brackets (not supplied).
Remove one screw
at the bottom of the
cooktop body on both
sides and secure the
bracket with those
screws. Then, secure
the brackets to the
cabinet sides.
■ Insert hold-down
bracket into highest
slots on the right and
left sides of the
cooktop.
Cooktop has three
slots, the highest
available will depend on the thickness of the
countertop.
■ Secure the brackets to the underside of the
countertop with screws provided.
23
Step 5
Electrical Connections
■ Connect the 3-pin plastic plug from the blower/
motor assembly to the 3-pin plastic socket on the
underside of the vent, next to the conduit.
■ Slide the metal cover over the connection and
secure with screws.
■ Connect the 6-pin plastic plug from the downdraft
assembly to the 6-pin plastic socket on the underside
of the cooktop, next to the power cord.
■ Slide the metal cover over the connection and
secure with screws.
Step 6
Connect Power
Plug power cord into properly grounded receptacle.
3/8″
Electrical
6-pin socket
Pressure
regulator
Metal
cover
6-Pin plug
Electrical
supply cord
Service
plate
Gasket
Countertop
