REAR-FACING INSTALLATION WITH LATCH
12
1
7
6
5
4
3
2
LATCH belt must be routed through opening in
child restraint for
rear-facing mode.
(see page 29, fig. d
Belt must lay flat and not be twisted.
Adjust child restraint to recline position
(see fig. a and page 25, fig. a0LACE
rear-facingONVEHICLESEATEQUIPPEDWITH
LATCH anchors.
&OREASEOFINSTALLATIONEXTEND
LATCH belt to its
MAXIMUMLENGTH
(OOKCONNECTORSTOVEHICLELOWERANCHORS
(fig. b). Pull connectors to be sure they are
securely attached to the anchor points. (fig. c).
Press down firmly in center of child restraint
while pulling
LATCH adjustment belt. (fig. d).
0ULLFRONTTOBACKANDLEFTTORIGHTATBELTPATH
TOCHECKFORSECUREINSTALLATION(fig. e)4HE
CHILDRESTRAINTSHOULDNOTMOVESIDETOSIDEOR
FORWARDMORETHANINCHCM
#HECKTHATTHELOWERANCHORAGEBELTSTAYS
tight and does not slip from the tightened
position. If it does not stay tight, try another
SEATINGPOSITIONORCONTACT#USTOMER3ERVICE
#HECKLEVELINDICATORONCHILDRESTRAINT
Vehicle mustBEONLEVELGROUND and child in
CHILDRESTRAINTWHENCHECKINGLEVELINDICATOR
Ball MUST be entirely in blue zone (fig.f). If
necessary, place rolled towels under child
RESTRAINTATVEHICLESEATCREASEUNTILENTIREBALL
ISINBLUEZONE4HENRECHECKLEVELINDICATOR
(see pages 24-25, fig. c
DO NOT use tether
rear-facing4ETHERmust
BESTOREDSEEh4ETHER3TORAGEvPAGE
0ERFORMTHISTESTEVERYTIMEYOUDRIVEWITHYOUR
child.
