Local I/O Cabling 41
CAUTION: Before disconnecting the local I/O cable, observe
the following guidelines:
•
•
•
•
•
•
•
•
Completely log out of the current iLO session before disconnecting
from the iLO port. Do not remove the local I/O cable when the UID
LED is flashing.
Always squeeze the locking buttons on the side of the server blade
connector before disconnecting from the I/O port. Failure to do so
can result in damage to the equipment.
Connecting Locally to a Server Blade with Video and
USB Devices
To connect locally, use the local I/O cable and any of the following USB devices:
Monitor
USB hub
USB keyboard
USB mouse
USB CD-ROM drive
USB diskette drive
Numerous configurations are possible. This section offers two possible
configurations.
Accessing a Server Blade with Local KVM
CAUTION: Disconnect the local I/O cable when not in use.
The port and connector do not provide a permanent connection. Rear
iLO connector performance degrades when the local I/O cable is
connected, even if the iLO connector on the cable is not in use.
NOTE: For this configuration, a USB hub is not necessary. To connect
additional devices, use a USB hub.
1. Connect the local I/O cable to the server blade.
