hp dvd-writer
hp dvd-writerhp dvd-writer
hp dvd-writer
dvd100i
dvd100idvd100i
dvd100i
Technical Support Solutions Guide 10/25/01 System Requirements
15
1515
15
⇐
⇐⇐
⇐
⇒
⇒⇒
⇒
Chapter 2 Drive Specifications
This chapter describes the specifications for the hp dvd-writer dvd100i drive and is
organized as follows:
System Requirements
The hp dvd-writer dvd100i drive is an internal IDE DVD+RW/CD-RW drive with an
EIDE-(ATAPI), MMC compliant interface.
The hp dvd-writer dvd100i drive functions on a desktop PC that meets the following
minimum guidelines:
■
Windows 98, Windows 2000 Professional, and Windows Me (Windows NT 4.0
Workstation with SP5 for data storage applications only) (Future – Windows XP
Personal and Professional)
■
Data applications:
●
Pentium II 450Mhz or equivalent processor
●
64 MB RAM
■
DVD video disc creation applications:
●
Pentium III 800Mhz or equivalent processor
●
128 MB RAM
●
video capture capability
■
hard disk space available
●
150 MB for included software installation
●
5 GB for DVD disc creation
■
An IDE controller with available connector
NOTE:
NOTE: NOTE:
NOTE:
Windows NT 4.0 Server, Windows 2000 Server/Advanced Server, and all
versions of Windows CE are not supported.
Physical Specifications
Mounting
■
The hp dvd-writer dvd100i drive is mountable in either horizontal or vertical
configurations.
■
Mounting screws = M3x10mm
■
The mounting screws should not extend into the drive more than 6mm.
See Figure 1 and Figure 2 page 16 for the positions of the mounting screws.
System Requirements p. 15
Physical Specifications p. 15
Reliability Specifications p. 23
Acoustic Emissions p. 23
Electrical Specifications p. 24
Performance Specifications p. 25
Environmental Specifications p. 27
Product Safety Specifications p. 28
References p. 29
