A SERVICE OF

logo

Removal and replacement procedures 33
Figure 5
Removing the Hard Drive Assembly
WARNING: Ensure that the system is powered off and all power sources have been disconnected
from the server. Voltages are present at various locations within the server whenever an AC power
source is connected. This voltage is present even when the main power switch is in the off position.
To install the hard drive:
1. Unlock the HDD carrier latches.
2. Rotate the HDD carrier handle up.
3. Align the five pins on the HDD carrier to their holes on the two sides of the HDD cage, and insert
the HDD into the HDD cage.
4. Push the HDD along the direction of the arrow to lock the five pins.
5. Rotate the HDD carrier handle down.
6. Lock the HDD carrier latches.