38
• Rain for the last hour
• Rain for the last 24 hours,
• Yesterday rain
• Last week
• Last month.
Tip: For the rain rate estimate the Last Hour rainfall value is understood as “inch/hr” or “mm/hr”.
Programming Rainfall Amount Units
In the Rain Window, press and hold SET button to program the rainfall units in mm or inches.
Resetting the Rainfall Statistics Memory
In the Rain Window, press and hold MEMORY button to reset all rainfall statistics.
Activating or Deactivating Rain Alarm
• In the Rain Window press ALARM/CHART button to display either the current rainfall or
the daily rainfall alarm (with “ALARM HI” displayed)
• If the rain alarm is disabled, the abbreviation “OFF” will be displayed; otherwise the
rainfall alarm amount will be shown
• When the rainfall alarm amount is displayed, press UP ▲to activate or DOWN ▼ to
deactivate
Programming Daily Rainfall Alarm
• In the Rain Window, press ALARM/CHART button to display the rainfall alarm
• Press and hold ALARM/CHART button until the “ALARM HI” will flash
• Set the desired amount for the rainfall alarm using UP or DOWN arrow buttons. Press
and hold either button for fast digits advance.
• Press ALARM/CHART button to confirm selection and the unit will return to the rainfall
alert display.
Wind Window
Wind direction is shown by compass points (i.e. NW) or in bearings starting from north (i.e. 22.5º).
The unit displays anemometer temperature or wind chill, average wind speed (over the past 10
minutes), gust, and wind other information. It records the maximum wind speed and gusts collected
during the day. Wind speed and gust alarms can be programmed based on pre-configured limits.
Wind speed is displayed in km/h, mph, m/s or knots.
Accessing Wind Mode
From the main unit: Press UP or DOWN until the WIND icon
on the display starts flashing.
From the remote control: Press
.
