11
5. PROBLEM SOLVING
• If the "LOW BAT" icon is displayed on the LCD readout at any time,
the batteries should be replaced as soon as possible.
• When the unit is in the power on mode and the LCD displays "000%,"
the sensor is not connected properly. Check the sensor connection
and if the condition persists, contact the Maxtec Customer Service.
• If, at any time, "ErX" (i.e. Er1, Er4, etc.) appears on the LCD readout,
contact the Maxtec Customer Service.
6. CLEANING AND MAINTENANCE
• When cleaning or disinfecting the MAXO2 analyzer, take appropriate
care to prevent any solution from entering the instrument.
• The MAXO
2 analyzer’s surface may be cleaned using a mild
detergent and a moist cloth.
• The MAXO
2 analyzer may be disinfected using standard topical
disinfectants.
• The MAXO
2
analyzer is not intended for steam, ethylene oxide or
radiation sterilization.
• Store the MAXO
2
analyzer in a temperature similar to its ambient
environment of daily use.
R213M15K.qxd 6/26/2006 8:59 AM Page 13
