9
TROUBLESHOOTING
29
If your transceiver seems to be malfunctioning, please check
the following points before sending it to a service center.
POSSIBLE CAUSE SOLUTION REF.
No power comes on. • The battery is exhausted.
• Bad connection for the battery pack.
• Recharge the battery pack.
• Check the connection to the
transceiver.
pgs. 25,
26
No sound comes from the
speaker.
• Squelch level is too deep.
• Volume level is too low.
• Set squelch to the threshold point.
• Set [VOL] to a suitable level.
pgs. 9, 11
Transmitting impossible. • Some channels are receive only.
• The battery is exhausted.
• Change channels.
• Recharge the battery pack.
p. 12
p. 25
The displayed channel
cannot be selected.
• Lock function is activated.
• Push [F], then push [7 (KEY LOCK)].
p. 10
Scan does not start. • All memory channels are not
programmed as “TAG ” channels.
• Set the “TAG” settings of desired
channels.
p. 16
No beep sounds. • Beep tones turned OFF. • Push [F], then push [8 (BEEP)] to
adjust the beep tone level.
p. 9
PROBLEM
