30
8
SET MODE
■ General
Set mode is used for programming infrequently
changed values or conditions of functions. The
IC-R8500 has 2 separate set modes: quick set mode
and initial set mode.
D Selecting quick set mode
qPush
[SLEEP/
] for 1 sec.
•Quick set mode is selected and one of its items appears.
wRotate the [M-CH] control to select the desired item.
eRotate the main dial to set the values or conditions
for the selected item.
rRepeat steps w and e to set other items.
tTo exit quick set mode, push
[SLEEP/
] again.
•Pushing any other switch will also exit quick set mode.
D Selecting initial set mode
qPush [POWER] to turn power OFF.
wWhile pushing
[SLEEP/
] push [POWER] to turn
power ON.
•Initial set mode is selected and one of its items appears.
eRotate the [M-CH] control to select the desired item.
rRotate the main dial to set the values or conditions
for the selected item.
tRepeat steps e and r to set other items.
yTo exit initial set mode, push [POWER] to turn
power OFF.
uPush [POWER] to turn power ON again.
•The conditions selected in initial set mode are now effec-
tive.
