9
1995-1997 - INLINE, INC PATHFINDER OPERATION MANUAL - REV2.1A May 19, 1997
RGB Delay:
RGB Delay is a key feature of the PATHFINDER. It provides an adjustable delay time (0 to 6 seconds)
between switching the sync and RGB boards. The sync signal is connected first and the RGB signals are
blanked while the display device is allowed to lock up to the new signal.
RGB delay prevents the display device from showing re-sizing and other spurious
on-screen effects which often occur while the display is adjusting to the new signal.
Enter this section by pressing the ENTER/SELECT button when the screen reads as follows:
The following screen will appear:
At 0.0 Seconds, the RGB and the sync will switch at the same time. To adjust the delay, use the UP and
DOWN scroll buttons. The UP scroll button will increase the delay up to 6.0 Seconds in 0.5 second
intervals. The DOWN scroll button decreases the delay time.
To exit this section with no change to the RGB Delay, press the MENU button. To activate the delay time
you entered, press the ENTER/SELECT or SAVE/RECALL button as follows:
ENTER/SELECT:
Pressing the ENTER/SELECT button will temporarily store the RGB Delay setting until the power
is turned off. This feature can be used to try different settings without overwriting the existing
setting previously stored. Upon re-applying power to the PATHFINDER, the RGB Delay setting
will return to its previously saved setting.
SAVE/RECALL:
Pressing the SAVE/RECALL button will save the RGB Delay setting in memory and will use it
every time the unit is powered on. This setting will remain until you tell the unit to Save a different
setting or reset the PATHFINDER to Factory Default (see Power On Settings on page 13 for more
details).
