9
q8 9 wp
ENGLISH
8 ASPECT button/lamp
Changes the aspect ratio of the picture from 4:3 to
16:9.
• When “16:9” is selected, the lamp lights up.
• To return to 4:3, press the button again.
• Use this function when the picture of 16:9 aspect
ratio is squeezed into 4:3 format signal.
NOTE:
• When displaying the picture in the 1:1 mode (☞ “ 7
SCAN SIZE button/lamp” on page 8), this function does
not work. In this case, “NO EFFECT” is displayed for
about 5 seconds (the lamp lights up).
9 BLUE CHECK/COLOR OFF button/lamp
Changes the video signal element to display.
• When “BLUE CHECK” or “COLOR OFF” is
selected, the lamp lights up.
Normal display = BLUE CHECK (Only blue
signal) = COLOR OFF (Only luminance signal) =
(back to the beginning)
p INPUT SELECT buttons/lamps
Select an input to display.
VIDEO 1: Selects the video signal input to the
VIDEO 1 terminal.
VIDEO 2: Selects the video signal input to the
VIDEO 2 terminal.
COMPO.: Selects the video signal input to the
COMPONENT terminal.
SDI 1: Selects the video signal input to the SDI
1 terminal.
SDI 2: Selects the video signal input to the SDI
2 terminal.
• The corresponding audio signal is also selected.
q STANDBY/ON button
Turns on and off (standby) the monitor.
NOTE:
• To disconnect the mains line completely, unplug the AC
plug from the wall outlet.
7 About the status display
When “STATUS DISPLAY” is set to “ON” (☞ page
17), the status (information of the current input
and the monitor settings) is displayed for about 5
seconds in the following cases:
• When you press the INPUT SELECT button of the
current input.
• When you change the inputs.
• When the signal condition of the current input
changes.
1 Input status
2 Signal format
• “NO SYNC” is displayed when no video signal
is input.
• When “COLOR SYSTEM” is set to “AUTO”
(☞ page 14), “OTHERS” is displayed for a
noncompliant composite signal input.
• “Out of range” is displayed for a noncompliant
component or SD SDI signal input.
3 Setting of SCAN SIZE
☞ “7 SCAN SIZE button/lamp” on page 8
VIDEO 1
NTSC
OVER
w Power lamp
Lights in orange:
The monitor is off (standby).
Flashes in orange:
The monitor is in the suspend mode.
Lights in Green:
The monitor is on.
Unlit:
The monitor is off (the AC plug is not
connected).
03_TM-15L1D-EN2.indd 903_TM-15L1D-EN2.indd 9 06.11.15 1:07:34 PM06.11.15 1:07:34 PM
