GENERAL INFORMATION
l
UNPACK
REMOVE
INTERIOR
PACKING
OPEN BOTTOM FLAPS
FIGURE 3
FIGURE 4
1
Lay carton on rear face and break open bottom
flaps
2 Set carton upright with all four flaps outward.
See Figure 3.
3
Lift carton u
p
and off of machine.
4 Remove all tape and packaging material from the
outside and inside of the cabinet. See Figure 4.
5R emove the front grill: take out the screws secur-
ing the grill at the bottom and Ilft It free of cabinet
6
Turn the fan by
hand to make certain It moves
freely.
7L
oosen
thumb screws holding cutter grid and water
pan
to “thumb tight.”
. UTILITIES
ELECTRICITY
DRAIN
OBSERVE LOCAL CODES
Each installation is unique but will require:
2 Either a
gravity drain system or a sump pump
to lift
Ihe water lo an existing drain.
3 An electrical branch circuit
of 115 Volt, 60 Hz, 1 phase,
with
a 15 Amp delayed action fuse or circuit breaker.
l
LOCATE UNIT
THIS UNIT MUST BE
I-J
INSTALLED IN AN
goo FlYlI
AREA PROTECTED FROM
( BEST
THE ELEMENTS, SUCH
AS WIND, RAIN, WATER
7oo F
\ RANGE
SPRAY OR DRIP.
CR 66A
1
Place unit so the front side WIII be .completely
unobstructed. lo provide proper air flow
2 Area should be well ventilated with temperature
above 55-F and below 110°F. Best results are
obtained between 70°F and 90°F.
3 ProvIsIon for electrlclty, water and drain connec
tlons should be determlned
4 The unit may be closed tn on the top and three
sides. but the front
MUST BE
unobstructed for air
clrculatlon and proper operation
Installation
should be such that the cabinet can be moved
forward for servlclng. If necessary
l
LEVEL UNIT
1
After placing unit In posItIon. check to make
certain the unit
IS
level side to side and front to
back.
2 Accurate leveling
IS
essential for proper
operation.
3 Unit should be shimmed so that it
IS
solid as well as
level. The shims should
be of hard permanent type
material such as masonite.
4
Compliance with National Sanitation Foundation stan-
dards require that this type of product be sealed to the
floor at the bottom rail in order to prevent contamination
from spills or the entrance of vermin. Therefore, we
recommend that when installing this product you seal it
to the floor in accordance with those standards. A
silicone-type sealer is recommended.
1
A cold water inlet of 1/4” OD soft copper tubing and
a shut-off valve.
3
