USB cableTrigger cable
Power supply cable
Synchronous cable
All cables connected
Connect the cable with “ ” mark facing to-
wards the LCD monitor of the digital camera.
k
9
2.1 Installing the system
1
Place the instrument on a powered optical table (optional accessory).
observe the following precautions when moving the instrument.
• Fasten the moving component xing screw.
• Put your hands under
the power supply unit and lift the instrument as
shown in the right gure.
• Do not lift the instrument with holding any parts other than the above.
• Check
the place
where you are going to set the instrument is at with no
obstacle that may catch your hand.
• Be careful not to pinch your hand during installation.
2
Make sure that the power switch is in OFF (“
q
”) position.
3
Install the digital camera in the camera mount.
2 Installation
5
Ensure that an eye piece cap is attached to the viewnder of the digital
camera.
4
C
onne
ct the synchronous, power supply, trigger and USB cables to the
digital camera.
k
