1.3 SETUP
Read the entire Operation Manual before setting up the Lifecycle Upright Bike.
ELECTRICAL POWER REQUIREMENTS
The Lifecycle Upright Bike requires an AC power supply according to the electrical configurations
listed in the chart below.
NOTE: Do not modify the plug provided with this product. If the plug does not fit into an available
electrical outlet, have a proper outlet installed by a qualified electrician.
WHERE TO PLACE THE LIFECYCLE
®
UPRIGHT EXERCISE BIKE
Following all safety instructions in Section 1.1, move the bike to the location in which it will be used. See
Section 7, titled Specifications, for the dimensions of the product footprint (assembled dimensions). Allow
a distance of 8 to 12 inches, or 21 to 30 centimeters, between the bike and other objects or surfaces on
either side. Allow a distance of 3 feet, or 1 meter, from the front or rear of the bike to any other object or
surface.
HOW TO STABILIZE THE LIFECYCLE UPRIGHT EXERCISE BIKE
After placing the bike in position, check the unit’s stability by attempting to rock it from side to side.
Any slight rocking indicates that the unit must be leveled. Determine which foot is not
resting completely on the floor. Loosen the jam nut (A) with an open-end 9/16-inch wrench, and rotate
the stabilizing foot (B) to lower it. Verify that the bike is stable, and repeat the adjustment as neces-
sary until the unit no longer rocks. Lock the adjustment by tightening the jam nut against the stabilizer
bar.
8
Supply Voltage
(VAC)
100
110
120
200
220
230
240
Frequency
(Hz)
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
Rated Current
(Amps)
1.6
1.6
1.6
.8
.8
.8
.8
