16 Kurzanleitung
MX5 CE .NET Benutzerhandbuch E-EQ-MX5CEOGDE-D-ARC
Anbringen des Haltegurts (optional)
Hinweis: Sie können wahlweise den Griff oder den Haltegurt am MX5 anbringen, aber nicht
beides gleichzeitig. LXE empfiehlt, den Haltegurt immer zur verwenden, wenn kein
Auslösegriff benutzt wird.
An elastic hand strap is available for the MX5. Once installed, the hand strap provides a means for
the user to secure the computer to their hand. It is adjustable to fit practically any size hand with
or without workgloves and is easily moved aside to allow installation or removal of the main
battery pack.
Abbildung 15 MX5 mit angebrachtem Haltegurt
Anbringung
1. If a handle is installed, remove it at this time. See section “Install Pistol Grip Handle.”
2. Slip the strap through the upper bracket prior to securing the upper bracket to the unit.
3. When slipping the strap through the bracket make sure the closed loop fastener surface is up.
4. After slipping the strap through the bracket, fold the strap over so that the two closed loop
fastener surfaces mate evenly.
5. Prior to securing the upper bracket to the unit, slide the bottom assembly into the slots at the
bottom of the MX5. Insure that both ends of the bottom assembly are securely installed.
6. After securing the bottom of the strap to the MX5, loosen the closed loop fastener strap and
then secure the upper bracket to the unit with a screw(s).
Entfernen
1. Separate the closed loop fastener tabs and loosen the strap through the upper bracket.
2. Using a Phillips screwdriver, remove the upper bracket screw(s).
3. Pull the bottom assembly from the slots in the bottom back of the MX5.
Slide the bottom bracket out and away from the MX5 when replacing the Battery Pack.
Periodically check the handstrap for wear and the connection for tightness. If the handstrap gets
worn or damaged, it must be replaced. If the handstrap connection loosens, it must be tightened
before the MX5 is placed in service.
