Introduction 1
1-5
1.5.2 FX
2N(C)
CPU all versions
Peripherals Table
Description Model Number
System software version with
full support for FX
2N(c)
Hand held pro
rammer (HHP) FX-10P-E from V 3.00
HHP cassette FX-20P-MFXA-E from V 3.00
Data access units
FX-10DU-E from V 4.00
FX-20DU-E Supports up to FX devices onl
FX-25DU-E from V 2.00
FX-30DU-E from V 3.00
FX-40DU-E(S) Supports up to FX devices onl
FX-40DU-TK-ES from V 3.00
FX-50DU-TK(S)-E from V 2.10
F940GOT-SWD(LWD)-E All versions
Usin
the new Interrupt Pointers:
To pro
ram new Interrupt Pointers I010
throu
h I060 in to the HSCS (FNC 53)
instruction with older pro
rammin
equipment, substitute the followin
special M codes for the appropriate
Interrupt Pointer; see the table ri
ht.
Existing Instruction And Special M Coil
Combination To Mimic The Operation
Of The Identified Interrupt pointer
Existin
Auxiliar
Coil
used to replace the identi-
fied Interrupt Pointer
Interrupt Pointer
M8181 I010
M8182 I020
M8183 I030
M8184 I040
M8185 I050
M8186 I060
Usin
M8198 with the BMOV instruction:
With old software and peripherals, file re
isters can not be used as a destination device in the
BMOV (FNC 15) instruction. To BMOV data into file re
isters with old equipment set special M
coil M8198 on. This switches the source and destination parameters; i.e., the source is then
treated as the destination and the destination becomes the source.
General note:
I
nore the special pro
rammin
techniques identified in this section if usin
updated
pro
rammin
software or peripherals; then normal operation, as identifiedin the followin
sections, will appl
.
The introduction of this CPU provides the FX user with man
new devices and instructions. To
use the full features of the FX
2N(C)
units the user must up
rade older software and hardware
pro
rammin
tools.
However, because of the downward compatibilit
of the FX
2N(C)
, it is not necessar
to up
rade
existin
pro
rammin
tools for use with FX
2N(C)
units up to the equivalent functionalit
of FX
CPU ver 3.30 units.
