No. 99MBC071A
LSM-6900 Display Unit.
Model No. LSM-6900
544-495 (mm/E)
544-496 (mm/inch)
Display unit
Code No. Note 1, Note 2
16-digit dot-matrix type display (upper) + 11-digit 7-segment display (lower) and 7 guidance LEDs.
Measuring functions Segment specification: 1 to 7 (1 to 3 for transparent objects) Edge specification : 1 to 255 edges
Arithmetical average
Moving average
1 to 2048 times
32 to 2048 times
Averaging method
Tolerance judgment ( NG, GO), Multi-limit selection (7 stages), Offset/zero-set, Mastering, Group
judgment, Abnormal value elimination, Automatic workpiece detection, Setting the reference data,
Data output, Sample measurement, Statistical processing , Simultaneous measurement, Automatic
measurement with edge specification, Transparent object measurement (Segment: 1 to 3), Workpiece
position display, Key entry prohibition, mm ↔ E changeover, Dual-gage calibration, Model number
identification, Setting the resolution, Display of comma ( ) to mark the thousandth digit, Setting the
number of blank-out digits, Setting the GO/NG judgment method, GO/NG judgment + analog output in
the ready state, Setting the I/O port, Laser power deterioration monitoring.
Remark: There are some restrictions on the combination of the above functions.
Power switch Key switch
Mass Approx. 5 kg
Safety Compliance with EN61010-1(OVERVOLTAGE CATEGORY , POLLUTION DEGREE2)
Optional I/F
To be additionally installed in the option slot: Either of the Second I/O Analog, BCD, and GP-IB
¥ interfaces
To be additionally installed in the dedicated slot: Digimatic Output Unit I/F
0 to 40
C, 35 to 85% RH (without condensation)
Standard interface unit Analog I/O interface, RS-232C, Footswitch
Scanning control
signal connector
Standard accessory
Operating environment
100 - 240 VAC 10%, 50/60 Hz, 40 VA
Rated power supply
2000 m or lower
Operating altitude
-15 to + 65
C, 20 to 90% RH (without condensation)
Storage environment
Remote interlock connector Standard accessory
Note1 : This Code No. is a set Code No. of the Measuring Unit LSM-902 and the Display Unit LSM-6900.
Note2 : Be sure to confirm that the Measuring Unit LSM-902 and the Display Unit LSM-6900 to be connected have the same serial numbers.
If the serial number of the Measuring Unit is not consistent with that of the Display Unit, the measuring accuracy cannot be
guaranteed.
