A SERVICE OF

logo

Open as PDF
next previous
3
4
Lower the opening mechanism into place,
pressing down on the Cutting Lever (4). The
Magnetic Lid Holder (6) will connect to the lid
and the multifunction opener will start
automatically.
3
Move the unopened can into place. Position
the rim of the can below the Guide Pin (5) and
on top of the Geared Wheel (7).
22
Raise the Magnetic Lid Holder (6) up and lift
the Cutting Lever (4).
5
When the can has stopped moving, hold the
opened can and lift the Cutting Lever to
release the can.
Using your multifunction opener
1
Plug the multifunction opener into a mains
outlet.
• The motor will automatically stop when the can is
open.
• It is not necessary to hold the lever down or hold
the can while it is being opened.
• If there is a bump, dent, or heavy seam in the rim
of the can, open the other end of the can or start
the cutter just beyond it.
• The motor of the can opener is permanently
lubricated and will require no oiling.
Notes:
46718 rev2_Layout 1 02/09/2011 12:13 Page 3