H–1
H
Tips on Speedlight Care and Reference Information
Tips on Speedlight Care and Reference Information
H
This section explains troubleshooting, Speedlight care, specifi cations and optional
accessories.
Troubleshooting
If a warning indicator appears, use the following chart to determine the cause of
the problem before taking the Speedlight to a retailer or Nikon representative for
repair.
Problems with the SB-910
Problem Cause Solution
0
The power cannot be
turned on.
The batteries are not
correctly installed.
Insert the batteries correctly. B-6
Battery power is weak. Replace the batteries. B-7
The fl ash-ready
indicator does not
light up.
The standby function is
activated.
Press the camera shutter-•
release button halfway.
Turn the SB-910 on.•
E-22
Battery power is weak. Replace the batteries. B-7
The SB-910 does
not fi re.
The fl ash function is canceled
in the custom settings
Activate the fl ash function in
the custom settings.
B-18
The effective fl ash
output distance range
does not appear.
The fl ash head is not set to
the forward-facing position.
Set the fl ash head to the
forward-facing position.
B-9
Aperture and ISO sensitivity
information has not been
received from the camera.
Check camera settings.•
Detach and reattach the •
SB-910 to the camera.
—
The SB-910 cannot receive
focal length information from
the camera.
Turn the SB-910 and camera
off, and then turn them on
again.
—
Zoom head position is
not set automatically.
The built-in wide panel is in
use or the Nikon Diffusion
Dome is attached.
Remove the built-in •
wide panel or the Nikon
Diffusion Dome.
Allow the zoom head •
position to be manually set
in the custom settings.
B-20
E-6
E-10
Power zoom function
is canceled.
Activate the power
zoom function.
E-19
