39
Chapter 3 Recording and Playback
Interval recording (INTERVAL REC)
This function is used to record 1 frame at the time interval
set in the INTERVAL TIME item.
1 frame
recording
1 frame
recording
1 frame
recording
(time)
Set INTERVAL
TIME setting
Set INTERVAL
TIME setting
1
Check that the SYSTEM SETUP screen is set
up as described on page 38.
For details on menu operation, refer to [Using the
menus] (page 120).
2
Select INTERVAL in the menu option REC
FUNCTION in the RECORDING SETUP
screen.
3
Set the time in the menu option INTERVAL
TIME in the RECORDING SETUP screen.
4
Press the REC button.
• The camera will repeat 1-frame recording for the
time interval set in the INTERVAL TIME option.
• Press the STOP button to stop recording.
• To cancel this function, turn the camera off or
select NORMAL in the REC FUNCTION option.
• The following indications appear to the left of the
operation status display.
• During recording: “I-REC” stays lit.
• During a pause: “I-PAUSE” stays lit.
When a setting of less than 2 seconds is made
in step 3, “I-REC” blinks according to time
setting during recording.
• When stopped: “I-” in “I-PAUSE” blinks.
NOTE
• The pre-recording function is not available.
• Sound is not recorded.
• Data recorded (until the STOP button is pressed) in
this mode is recorded as a single file.
• There is no output from the DVCPRO/DV connector.
One-shot recording
(ONE SHOT REC)
This function records a single shot at each unit of time
which has been set.
1
Check that the SYSTEM SETUP screen is set
up as described on page 38.
For details on menu operation, refer to [Using the
menus] (page 120).
2
Select ONE SHOT in the menu option REC
FUNCTION in the RECORDING SETUP
screen.
3
Set the time in the menu option ONE SHOT
TIME in the RECORDING SETUP screen.
4
Press the REC button.
• The camera will pause recording after making a
recording that lasts the duration set in step 3.
• Press the STOP button to stop recording.
• To cancel this function, turn the camera off or
select NORMAL in the REC FUNCTION option.
• The following indications appear to the left of the
operation status display.
• During recording: “I-REC” stays lit.
• During a pause: “I-PAUSE” stays lit.
• When stopped: ”I-“ in “I-PAUSE” blinks.
NOTE
• No other functions are available during operation.
• The pre-recording function is not available.
• Sound is not recorded.
• Data recorded (until the STOP button is pressed) in
this mode is recorded as a single file.
• There is no output from the DVCPRO/DV connector.
• During continuous one-shot recording, recording
operation speed may be decreased.
