Recording
VQT4C72
23
Recording TV programmes
To set the recording time
1 Select “Recording Time” or “Continuous
recording” in step 3 (> left).
Recording Time:
You can set the length of recording time from
30 minutes to 4 hours.
• You can select the recording time with
[2, 1].
Continuous recording:
The recording is continued until you press
[STOP ∫].
2 Press [OK].
To convert the recording mode after recording
Refer to “DR File Conversion”. (> 38)
• One recording will terminate when simultaneous recording
is being done and timer recording starts.
• Teletext will not be recorded.
• Following operations cannot be performed while recording.
- playback of DivX file
- playback of photo
- copying of photo to the HDD
- copying of music to the HDD
- copying of AVCHD video to the HDD
• When “Automatic Standby after OTR” is set to “On” (> 77),
this unit is turned to standby mode if this unit is not
operated for approximately 5 minutes after completing
“Automatic Stop” or “Recording Time”.
• This operation will only record to HDD.
• Recording mode is DR only.
Performing “DR File Conversion” after
recording makes it possible to change the
recording mode. (> 38)
• This unit can record two programmes being
broadcasted at the same time.
1 Select the channel to record.
2 Press [¥ REC].
Recording starts.
• “REC1” or “REC2” will light on the unit’s
display.
3 Select “Automatic Stop”, then press
[OK].
• One touch recording (OTR)
Recording stops automatically when the
programme ends.
• You can also select “Recording Time” or
“Continuous recording”. (> right)
Automatic Stop ( Guide Link ) at 8:45
REC1/OTR
Recording Time
Continuous recording
30 min
8:00 - 8:45
DMRXW390GZ-VQT4C72_eng.book 23 ページ ２０１２年２月２８日 火曜日 午前９時８分
