Station Programming (Personal Programming) 2-3
2.1 Station Programming Instructions
To confirm the assigned data
—Be sure that you are in the Station Programming mode. Set the MEMORY switch to
“PROGRAM”.
PT
— To exit the Station Programming mode, set the MEMORY switch to “SET”.
— If you wish to change the data, follow the programming procedure explained in this
section.
* A program access number is required to program/confirm the data by Station Programming.
• Enter the program access number* as follows.
- 1: Preferred Line Assignment — Outgoing
- 2: Preferred Line Assignment — Incoming
- 3: Outside (CO) Line Ringing Selection
- 4: Intercom Alert Assignment
- 5: Call Waiting Tone Type Assignment
- 6: Self-Extension Number Confirmation (KX-T7030 and KX-T7130 only)
- 7: Extension Password Set (Manager only)
- 0: Date and Time Setting (Operator/Manager only)
• The display shows the programmed data.
<PT Display Example>
When you press “5”, the display shows:
— The Call Waiting tone is currently programmed to Tone 1.
C.W.Tone-1
• The display shows the initial programming mode.
