31
RQT8237
31
FM transmitter
You can enjoy listening to discs or SD cards through your FM radio channel (e.g. car stereo) by
transmitting audio signals from this unit.
p
The FM transmitter can also be used with normal FM radio-equipped devices.
To turn off the FM transmitter : Press [FM-TM] and then [
] to select “OFF”.
To exit the screen: Press [FM-TM].
Preparation: Unplug headphones and audio/video cable from the unit.
p
When connected, the FM transmitter will not work.
When this has not been successful
p
If you experience noise or distortion of audio, move the radio antenna closer to the unit. Or select
“MONO” from the menu screen using [
]. If the audio quality still does not improve, then
change the radio frequency (➜ above, “When this has not been successful”).
1
Play the disc or SD card. (➜ page 12 or page 14)
2
Press to display
the menu.
FM TRANSMITTER
STEREO
88.3 MHz
MONO
ON OFF
If the menu is not displayed, check the “Preparation” steps listed above.
p
No sound is heard from this unit. For the volume on this unit, set the on screen volume
level using the following indications.
– DVD movies: the far right side
– Others:near the middle
The above settings are to be used only as a rough estimate. Depending on the recording
conditions of the disc or card, the actual appropriate volume level may differ. If the volume is
inappropriate in step 5, readjust the volume.
3
ENTER
Press [
] to select “ON”.
The orange lamp next to the [FM-TM] button lights up.
4
Tune the radio to the 88.3 MHz FM frequency.
When another FM broadcast is heard.
(➜ see below, “When this has not been successful”)
5
Adjust the volume using the radio.
1
Press to display the menu.
2
Press
[
]
to select the frequency
(“88.3 MHz”) (factory preset) .
Press [] , to select a frequency between
88.3 MHz and 107.7 MHz which is not being
used by any broadcasting stations.
p
The frequency can be set in 0.1 MHz increments.
ENTER
Tune the FM radio into the fre
uenc
selected in ste
2.
3
Enjoying in a car
