Setting remote control signals for home
theatre systems
1
2
Press "SETUP" for 3 seconds or more.
3
3
-1
3
-1
Setting home theatre system devices when you do not know
the device code
When recording remote control signals for a home theatre system device when you do not
know the device code for that device, you canuse the search function to make the settings.
Turn the power on for the home theatre
system device that you would like to set.
Select the device to be set and then press
"ENTER".
When “DVD, VCR, AMP” is selected
٨
When “TV/TNR” is selected
٨
When “USER 1-3” is selected
٨
Select the device to be set and then
press "ENTER".
Press the up or down button to select
“SEARCH?” and then press "ENTER".
Press "DEFAULT".
4
5
6
3
-2
(Example: When “DVD” is selected)
Point the remote control at the home
theatre system device and press the
up button once.
Once the power for the home theatre
system device turns off, press "ENTER".
Repeat step 5 until the power turns off for the home theatre
system device.
Select the device to be set and then
press "ENTER".
Continue to step 5
Continue to step 4
Continue to step 4
To finish, press "SETUP", and
then check operation.
٨
٨
Device codes can be selected even if the learning function
has already been used to program the remote control
signals, but in such cases, the remote control signals that
have been learnt will have priority. If you would like to set a
device code for these buttons, delete the remote control
signals which have already been learnt. ( p. 9)
If operation macros have already been assigned to function
buttons the operation macros will have priority. If you would
like to set a device code for these buttons, delete the
operation macros which have already been assigned.
( p. 11)
Note:
8 - ENGLISH
