35
Set Touch Pen mode.
Select “TOUCH-PEN SETTINGS” in “SETUP” menu and press
button.
When a Terminal Board with dual input terminals is installed, “SLOT INPUT” is
displayed as “SLOT INPUT A” and “SLOT INPUT B”.
TOUCH-PEN SETTINGS
OFF
SLOT INPUT
HDMI
OFF
OFF
OFF
NETWORK
DVI
PC
OFF
TOUCH-PEN SETTINGS
TOUCH-PEN MODE
TOUCH ONLY
TOUCH-PEN MODE
Select an appropriate setting for the function of the electronic pen used.
TOUCH ONLY: Contact-type Touch Pen
TOUCH & REMOTE: Contact-type Touch Pen and remote pointer
SLOT INPUT ʊ NETWORK
Set “ON” or “OFF” for each input terminal.
If you switch to the input terminal that is set to “ON”, the mode becomes Touch Pen mode.
“TOUCH-PEN: ON” is displayed in Touch Pen mode.
Notes:
• When the following signal input, “TOUCH-PEN SETTINGS” are disabled:
50i/50p/25p/24sF/24p signals and PC format signals with 50 Hz vertical frequency.
• The electronic pen cannot be used when VIDEO or COMPONENT input is selected.
•
The electronic pen cannot be used during Digital Zoom. (see page 22)
• When using the electronic pen, adjust “POS./SIZE” so that the screen of the computer can be correctly displayed.
(see page 24)
Setting the Remote Control
You can also turn Touch Pen mode ON/OFF with the FUNCTION buttons on the remote control. (see page 43)
In Touch Pen mode, the menus and functions are restricted as follows.
POS./SIZE menu
1:1 PIXEL MODE: ON
OVER SCAN: OFF
PICTURE menu
PICTURE MENU: Fixed to “STANDARD”
(see page 27)
SETUP menu
SIGNAL
EXTENDED LIFE SETTINGS
MULTI DISPLAY SETUP
PORTRAIT SETUP
FRAME CREATION: OFF
PICTURE MENU:
Fixed to “STANDARD”
(see page 38)
MULTI DISPLAY SETUP: OFF
PORTRAIT SETUP: OFF
Options menu
Display size: Unavailable
Rotate: Unavailable
ASPECT Controls FULL
ON
TOUCH-PEN
