18
Picture Menu
By pressing the Normal “N” button on the Remote Control while the Picture menu is displayed, the selected menu
will be changed to the Normal Mode.
Normalization will not occur if the menu is not displayed when the “N” button is pressed.
The Normal mode is the factory preset condition. Returning to this original condition is called “Normalization”.
Colour temperature
AIlows you to set the overall colour tone of the picture.
Press or to switch between modes
P-NR
(Picture Noise Reduction)
Automatically reduces unwanted picture noise.
Press or to switch between modes
Scan mode
Lets you choose the screen refresh method:
Press or to switch between modes
Switching is also possible using on the Remote Control to change the Picture
refresh setting between 75/833i, 100Hz and Progressive (for PAL signal).
Note:
• When viewing a PAL transmission (other than PAL 60) with
Scan mode
set to
Progressive
, the screen will flicker, this is not a fault.
Helpful Hint ( Normalization)
Standard Warm Cool
Picture
m
enu
M
enu
Con t rast
Br ightness
Colour
Sharpness
Colour te
m
perature
PNR
Scan
m
ode
Cinema
Standard
Auto
75/833i
Off
Weak
Auto
Strong
P i c t u r e
m
e nu
M
e n u
C o n t r a s t
B r i g h t n e s s
C o l o u r
S h a r p n e s s
C o l o u r t e
m
p e r a t ure
P – N R
S c a n
m
o d e
Dynamic
Warm
Weak
75/833i
Progressive
100Hz75/833i
P i c t u r e
m
e nu
M
e n u
C o n t r a s t
B r i g h t n e s s
C o l o u r
S h a r p n e s s
C o l o u r t e
m
p e r a t ure
P – N R
S c a n
m
o d e
Dynamic
Warm
Weak
75/833i
MODE FUNCTION
75/833i
The 75/833i mode gives a faster refresh rate and more lines
than a standard television.
100Hz
100Hz will give a steady picture for most signal
transmission.
Progressive Recommended when receiving NTSC signals.
100Hz/
PROGRE
N
TX32F500A-2912_E Page 18 Monday, July 18, 2005 6:05 PM
