56 C2630M-C (7/09)
PROGRAMMING A PATTERN
This section describes how to program a pattern. Certain PTZ devices, such as Pelco’s Spectra series domes, will display an on-screen message
stating the amount of remaining memory available for pattern programming.
Start Programming a Pattern
To program a pattern:
1. On the PTZ keypad toolbar, click the Live button .
2. Drag a camera from the Site Tree onto a view panel.
3. On the PTZ keypad, click the Set button to enter programming mode.
4. Using the PTZ keypad, select a number for the pattern (1-4).
5. Click the Pattern button .
6. Move the camera through a series of movements using the on-screen PTZ and focus controls.
Figure 26. Programming a Pattern
Stop Programming a Pattern
To stop programming a pattern:
1. On the PTZ keypad, click the Pattern button .
2. Click the Set button .
ᕤ
ᕥ
ᕣ
